The condenser is suitable for coal fired thermal power units, gas turbine units and nuclear power units, including million class double reheat ultra supercritical unit, CPR1000, AP1000, ACP1000, EPR. The arrangement of heat exchanger of our company has independent intellectual property rights. And its heat transfer performance is better than HEI standard, which can meet the requirements of back pressure of Northern cold zone, Southern warm zone, pure condensation unit, extraction condensation unit, direct water cooling and indirect air cooling. Mature single shell, double shell and three shell condensers can match a full range of low pressure cylinder of steam turbine. A series of professional design, such as vibration analysis and strength calculation, can ensure the safety of system. In addition, customizable equipment which is used to add water and remove oxygen and the design of throat can improve the economy of system.

• In order to improve the effect of heat transfer and reduce the flow resistance, we choose the best flow rates of steam and water by using advanced design calculation method. The design includes pipe system vibration calculations and shell support-specific seismic calculations. The performance of condenser is guaranteed through lot of experience in design and operation.
• In order to prevent the vortex damaging tube end, a special stainless steel housing is installed on the inlet port of the U-shaped heat transfer tube.
• In order to improve heat transfer efficiency and prevent corrosion of internal parts, we use an exclusive built-in air exhausting system to exclude the non-condensed gas of shell.
• In order to prevent the water from directly corroding the tube, a special vaporizer is set at the inlet port. In addition, we will separate the water and steam and guide them into different condensation sections.

The condenser is not only suitable for thermal power units, including subcritical, supercritical, ultra-supercritical, extraction, air-cooled, combined cycle ,but also it be applied to various nuclear power units. And design and manufacturing technology of our company reach the advanced level at home and abroad. The market share of our company ranks the top.

• 300 MW unit at the Rosa Power Plant in India
• 300 MW nuclear power unit at the Chashma in Pakistan
• 600 MW nuclear power unit at the Qinshan Nuclear Power Plant
• 600 MW unit at the Shidongkou Power Plant
• 660 MW unit at the Wangting Power Plant
• 600 MW unit at the HISAR Power Plant in India
• 1000 MW unit at the Yuhuan Power Plant
• 1000 MW unit at Phase 3 of the Waigaoqiao Power Plant project
• 1000 MW unit at the Shanghai Caojing Power Plant
• 1000 MW nuclear power unit at the Yangjiang Power Plant
• 1000 MW nuclear power unit at the Fangchenggang Power Plant
• 300 MW indirect air cooling unit at the Dawukou Power Plant
• F class gas-steam combined cycle unit at the Shidongkou Power Plant
• E-level gas-steam combined cycle unit at the Zhengchangzhuan Power Plant